Highlighted
Active participant

SAP Connection Test Fails - 'cannot be used for communication because it is in the faulted state'

All of our v14.1 and v14.2 beacons return this error message when hitting the 'test connection' button (screenshot attached) for any new SAP connection. However when we execute the connection it completes just fine so there's no issue with the data that we supplied. Does anyone have any suggestions?

Thanks,

Peter

0 Kudos
4 Replies
Highlighted
Moderator Moderator
Moderator

Re: SAP Connection Test Fails - 'cannot be used for communication because it is in the faulted state'

@peterikeda 

If you've got this resolved then please share your findings with the community if you think others could benefit from it. If not, you may want to raise a support case and request assistance in further troubleshooting...

Thanks,

0 Kudos
Highlighted
Rising star

Re: SAP Connection Test Fails - 'cannot be used for communication because it is in the faulted state'

Hi,

I have seen this happening for different types of connections over the years. I just don't rely on that test connection function anymore. Nice if it works, probably still ok if it doesn't.

Best regards,

Markward

Softline Group is Europe's leading independent expert in Software Asset Management.
Highlighted
Moderator Moderator
Moderator

Re: SAP Connection Test Fails - 'cannot be used for communication because it is in the faulted state'

I understand (@mfranz), so if you (@peterikeda) have access to an environment where this issue can be reproduced at will it may be beneficial to get it logged as a support case so that we can ask engineering to get it fixed.

Thanks,

0 Kudos
Highlighted
Active participant

Re: SAP Connection Test Fails - 'cannot be used for communication because it is in the faulted state'

@JohnSorensenDK  - I opened one last week, it's 02134041

0 Kudos