The Community is now in read-only mode to prepare for the launch of the new Flexera Community. During this time, you will be unable to register, log in, or access customer resources. Click
here
for more information.
I am trying to get corel draw Graphics Suite 11 to install. It comes as an MSI but it can only be installed via the setup.exe file. I have seen a post on the corel site that says I need to remove the action 'ISVerifyScriptingRuntime', which seems to work.
The other point it mentions is that several sub features in 'Writing tools' feature all install the same 3 merge modules and I would need to stop them being installed in order to get Active Dir to install the package. My question concerns the merge modules. I can't seem to find them using developer. They don't seem to show up anywhere. Can anyone help me?
For Adminstudio 3.5, launch the Developer IDE. In the view list, you should find Merge Modules under 'Configure the Target System'. The corresponding view in the right pane lists all the merge modules.
Actually, I am not sure if you don't see the merge modules view at all or you do'nt see the merge module in question not listed or checked in that view? BTW, This is the only place where you should see merge modules. If you don't see then probably the .msi doesn't have the merge modules.
2. Does the Merge Modules view not appear under Configure the Target System in Developer? The UI should look something like the attached file when you're in the view.
3. If you can see the Merge Modules view, do you see the merge modules you're looking for, or are they not displayed in the view?
There is no merge module section on the left but in the right hand side there is a small section that mentions merge modules but it does nothing when I click on it.
Also, I had an email from a curtis sawin who has had problems with corel 11 as well. He says I need to change the attirbute column for the Draw11Suite feature to 8. Where???
I have managed to fix it, without needing the merge modules. Corel used v7.02 which, apparently, had problems. Have updated the MSI with ISScriptBridgeLarge.dll and made a few changes and it now installs.
