The building in GUI mode (Linux) is working fine, but when I try to build the same program in console mode I am getting the following message: ..InstallAnywhere has experienced an error building/saving this project. Please consult the build log (console.txt) for additional information concerning this problem. For further assistance, please contact Macrovision Developer Technical Support. Exiting: 102..... Note: At this point the build.log is not generated neither the std_err.txt setup in Project-->Config "Send stderr to" Thanks in advance for any help, jcrphx ... View more

I am needing help to figure out what is wrong in my setup that is not generating the "Install Log". _How I am activating the "Install Log" feature in my IA2008 setup? Go to : Project|Info|Installation log Checkbox: Generate install Log during installation (Enabled) using (Plain text format). Note: I can see that the variable $INSTALL_LOG_DESTINATION$ is setup properly. I means is including the "USER_INSTALL_DIR+Product_Name+Installlog.log" but the "log" file is not created physically in my file system. ... View more

I am looking for a solution or pluging that allow me to install a file from the "pre-install" area instead of the current "install" area. I have been checking the IA2008's forum as well as the custom code stored in the Macrovision web side without success. I will appreciate any help on this matter. A litter bit more: A special validation need to be conducted on a specific file(driver) from an input step or panel allocated in the pre-install area. What we need : Actions in the Pre- install area. _Select and encapsulated the file from the pre-install area (pending for solution) _Install the file in a temporal folder (pending for solution) _From an input step located in the pre-install area to validate the file (done). _Delete the file from the temporal folder(done). Note: All this needs to happen before the installation of the whole application's package. Currently is the "install" task the only one designated to encapsulated files that will be installed. ... View more

I am using InstallAnywhere 2008. I am trying to display the $PRODUCT_NAME$-$PRODUCT_VERSION_NUMBER$ in the "Panel:Introduction:Introduction" of my Installer Wizard. The variable $Product_Name $ is displayed properly but not the $PRODUCT_VERSION_NUMBER$. I can see that this variable's value is setup in Project->Description->Version "2.4.5" so please can somebody help me to understand what I am missing ? ... View more