The Community is now in read-only mode to prepare for the launch of the new Flexera Community. During this time, you will be unable to register, log in, or access customer resources. Click here for more information.
- Flexera Community
- :
- Foundation / CloudScape
- :
- Foundation / CloudScape Forum
- :
- Unable to see all the subnets in "Export Scope" under Assets on Flex deploy
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
Hi,
I entered 140 subnets as part of the scope in RN150 however when the scan completed and I exported the "Export Scope" from Assets menu on FPD, I can only see 22 subnets. Does this mean RN150 was unable to hit /scan remaining subnets? What could be the possible cause? Firewall or something else...suggestions please. Thanks!
‎Jul 30, 2021 12:40 PM
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
Greetings,
A scanned subnet would be listed in the Exported Scope file, even if the RN150 is unable to reach any IP addresses on that subnet (typically due to a network firewall blocking traffic). It would display "0" in the "Accessible" and "Total IPs " columns of the export file for that subnet.
The behavior you are describing sounds like the subnets were entered on the virtual appliance, but only some of them were selected to scan. If you navigate to the console of the RN150, under subnets it will display the total subnets defined as well as the number of subnets selected for the next scan.
‎Aug 02, 2021 09:44 AM
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
Greetings,
A scanned subnet would be listed in the Exported Scope file, even if the RN150 is unable to reach any IP addresses on that subnet (typically due to a network firewall blocking traffic). It would display "0" in the "Accessible" and "Total IPs " columns of the export file for that subnet.
The behavior you are describing sounds like the subnets were entered on the virtual appliance, but only some of them were selected to scan. If you navigate to the console of the RN150, under subnets it will display the total subnets defined as well as the number of subnets selected for the next scan.
‎Aug 02, 2021 09:44 AM
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
Thanks for the clarification. Today, I checked the "Export Scope" again, looks like I am seeing all 141 subnets. I believe, there is a bit of lag in populating the real picture on FPD. I should have given some more time, just got little impatient. Anyways, I am happy now, thanks! 🙂
‎Aug 02, 2021 10:09 AM
- Question with regards to VMware Discovery in Foundation / CloudScape Forum
- Questions with regards to Flexera Foundation/Cloudscape subnet discovery in Foundation / CloudScape Forum
- Virtual Appliance > Subnet > Scan Selected, does not work in Foundation / CloudScape Forum
- Suggestions for improving location functionality in Foundation / CloudScape Forum
- RN150 Discovery Completed - no update on FlexDeploy dashboard nor assests in Foundation / CloudScape Forum
