- Flexera Community
- :
- FlexNet Manager
- :
- FlexNet Manager Forum
- :
- Re: vCenter inventory
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
vCenter inventory
Good morning for everyone, hope You are doing fine, on our customer we are trying to integrate the vCenter on one of their sites.
We are picking the correct inventory from one site using of their Beacons, but we are not succeeding on picking the inventory from other networking with their assigned beacon.
As can be shown on the table, it always detect the sytem as if vCenter was not discovered, but in fact it is active on the standard 443 port.
Beacons are on the same 2020R1 release.
If anyone guesses about it, what could be happenning here on this beacon inventory not discovering the vCenter parts?.
Much appreciated.
EDPPROMAINLAND2018 | 10.64.196.148 | VMware server has not been discovered on this device. | rsrvhypvc010 | VMware Inventory - Portugal | VMware inventory | 18/11/2020 2:05:30 | 18/11/2020 2:50:44 | Success |
EDPPROMAINLAND2018 | 10.64.196.149 | VMware server has not been discovered on this device. | rsrvhypvc020 | VMware Inventory - Portugal | VMware inventory | 18/11/2020 2:05:30 | 18/11/2020 2:50:44 | Success |
EDPPROMAINLAND2018 | 10.72.196.21 | VMware server has not been discovered on this device. | rsrvhypvc004 | VMware Inventory - Portugal | VMware inventory | 18/11/2020 2:05:30 | 18/11/2020 2:50:44 | Success |
EDPPROMAINLAND2018 | 10.72.196.20 | VMware server has not been discovered on this device. | rsrvhypvc003 | VMware Inventory - Portugal | VMware inventory | 18/11/2020 2:05:30 | 18/11/2020 2:50:44 | Success |
EDPPROMAINLAND2018 | 10.64.196.49 | VMware server has not been discovered on this device. | rsrvhypvc002 | VMware Inventory - Portugal | VMware inventory | 18/11/2020 2:05:30 | 18/11/2020 2:50:44 | Success |
This thread has been automatically locked due to inactivity.
To continue the discussion, please start a new thread.
- Mark as New
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @jjgarcia_sia,
This KB article is generally a good starting point for investigation into this sort of problem: Failure to run discovery on VMware vCenter/Host Servers in FlexNet Manager Suite On-Premises
Also - is ICMP permitted on this network where the discovery is failing? If not, then this KB may be of interest to you too: How to allow beacon network scans in a network with ICMP disabled
HTH,
Joseph
