Importing ini in new transform

[tagross]

I am trying to import an ini file into the System Configuration - Ini Files section of the configurator. It allows me to browse and select the ini file and prompts for the correct option (overwrite, etc) but when I complete the wizard the ini file does not show up. I do not receive any errors.

I need to change a key on install in this particular ini file.

BTW, the ini file is already present in the System Configuration - Files and Folders section.

I'm using Adminstudio for Zenworks version 6.0.

[LeslieEaster]

I'm not familiar with the Zenworks version of AS, however, I'm assuming this piece of functionality is the same.

Use the Editor to create the transform (File->New, Transform). Run the response transform if you need to. Go to System Configuration-->INI File Changes and right-click to create a new entry. Right-click to create a section reference and right-click again to create a value name reference. Fill in the value for value data and you should be set. Save the transform and give it a spin.