I'm trying to configure my service to have a recovery action to restart the service. I'm getting Error 1939 during install saying the service cannot be configured. I googled this and found others having this issue and the solution was to change the SCM Action Type from "Restart Service" to "Run Command" and have the command be "sc start ServiceName". I tried this and this did not work either. I'm still getting the Error 1939. This is causing the installer to fail and rollback (even though I have Error Control set to "Log the error and continue" and the Abort Install on Failure setting set to No). Does anyone know how to resolve this issue? I'm using InstallShield 2013 Service Pack 1. ... View more

Hi, I have an InstallScript project and am using InstallShield 2013. I want to disable Maintenance Mode. So if the program is installed and I run the installer again (or a newer version of the installer), it automatically will kick off the uninstallation rather than giving options for Modify/Repair/Remove. I know there used to be an option to disable Maintenance Mode in the General Properties, but I no longer see it. Also, when I run the installer now, if the program is already installed, I get an error that says the Version comparison failed. If I disable Maintenance Mode, will it automatically skip trying to compare the versions or is there a way I can get around that? Any help would be greatly appreciated. Thanks! ... View more