This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- .prq run issue
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Jun 04, 2011
03:37 PM
.prq run issue
I've created two new .prq files and they seem to be getting inserted into my MSI project. However, when I run the install it is ignoring my command line switches and using all defaults. Is there a way to log the steps where the command is issued so I can see what switches are being set? Is there a way to look into the setup.exe and see if the new .prq's are actually there? Any other thoughts?
(2) Replies
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Jun 06, 2011
04:00 PM
You can run your setup with the /debuglog parameter and it will spit out a lot of potentially useful information about prerequisites and other steps it takes. One thing that comes to mind is that both the regular and silent command line should be filled in if you need to pass special parameters to your prerequisite.
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Jun 06, 2011
07:12 PM
I found the problem. I created my new .prq by copying another and editing it. I failed to clear the alternate .prq download site for web download of prerequisites. The default .prq was being downloaded and used instead of my new one.