This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- LaunchCondition: How to localized the description message?
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Sep 20, 2013
09:55 AM
LaunchCondition: How to localized the description message?
Hi!
I've successfully created a launch condition for my MSI Basic setup which checks some stuff before the setup can be executed. The problem that I have now is that I somehow cannot localize the displayed description message.
Any hints on how to do that?
Regards
Ralf
I've successfully created a launch condition for my MSI Basic setup which checks some stuff before the setup can be executed. The problem that I have now is that I somehow cannot localize the displayed description message.
Any hints on how to do that?
Regards
Ralf
(2) Replies
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Sep 20, 2013
10:28 AM
You need to use the Install Condition setting in the General Information view. If you type a new message, the IDE automatically assign a new string ID. Or you can select a existing string entry by clicking the [...] button in the Message property grid.
Hope that helps.
Hope that helps.
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Sep 23, 2013
02:19 AM
Hello hidenori,
you are right: Using the "Install Condition" property in the General Information area makes it easier as the used string variable is shown there.
However if you use the "New Record" Wizard in the Direct editor it will also allow you to choose from one of the existing texts. However the used string variable is not shown in the wizard or later in the table which lets you think localization is not supported.
Thanks for support
Ralf
you are right: Using the "Install Condition" property in the General Information area makes it easier as the used string variable is shown there.
However if you use the "New Record" Wizard in the Direct editor it will also allow you to choose from one of the existing texts. However the used string variable is not shown in the wizard or later in the table which lets you think localization is not supported.
Thanks for support
Ralf