This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- ICE45 warnings to clean up
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Apr 29, 2008
12:49 PM
ICE45 warnings to clean up
I wanted to create a new install from scratch to start off with a clean validation list and right from the the get go I get 2 ICE45 warnings about ReadyToInstall.InstallNow and ReadyToRemove.RemoveNow controls that has bits set in the 'Attributes' column that are reserved.
Why does basic generated MSI project start out this way?
Looking at all my installs these two entries are always there. This seems to me to be an IS issue that they should resolve before releasing updated products. A clean install should at least start with no error or warnings in ICE...
Anyways the Attributes value of these controls are 8388611. So will setting these to 1 cause any issues that I should know about?
Thanks,
Why does basic generated MSI project start out this way?
Looking at all my installs these two entries are always there. This seems to me to be an IS issue that they should resolve before releasing updated products. A clean install should at least start with no error or warnings in ICE...
Anyways the Attributes value of these controls are 8388611. So will setting these to 1 cause any issues that I should know about?
Thanks,
(3) Replies
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Apr 29, 2008
12:57 PM
Actually setting to 1 will disable the button. So I re-enabled it and it then set the Attributes to 3.
But again my question still applies, why does the control initially start with this reserved value and what would be safe to set it too?
Thanks,
But again my question still applies, why does the control initially start with this reserved value and what would be safe to set it too?
Thanks,
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Apr 30, 2008
09:32 AM
I'm fairly sure (but haven't checked), that the extra bit set is the ElevationShield attribute. The version of the CUB file you are using is not aware of this bit, but it is actually defined since MSI 4. You are presumably not using the new CUB because the CUB files that came with MSI 4 did not execute properly except on Windows Vista. So in short I would recommend ignoring this error and leaving the ElevationShield attribute set.
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Apr 30, 2008
10:42 AM
So your saying that I should reset these back to 8388611 for this MSI 4 support?
![](/skins/images/A5EADE085F77DE82FB3B14D6B307AE6A/responsive_peak/images/icon_anonymous_message.png)