- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- I am getting install welcome dialog when I am trying to re-run the application
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Hi,
I build an Installer with the help of Installshield. I ran the installer when the product was not installed in my system. Later, I tried to re-run the Installer again. I expected Maintenance welcome dialog to popup but I got Install Welcome dialog.
What can I do to get the Maintenance Welcome dialog during the time of re-running the application
Thanks,
Naveen G
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Thanks for the Reply.
I realized my mistake. I didn't set the Condition for InstallWelcome Dialog Under Custom Action and Sequence -> "Sequence".
Condition as "Not Installed"
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
What is your project type?
Is your project installed successfully in the first time? Please check in control panel for entry after first time installation?
Are you trying to run second time from installshield IDE RUN button?
If you are trying to run from installshield IDE, then its expected, because by default installshield RUN button will uninstall the setup and then it will run the setup again,(its for testing purpose to make sure the setup is running successfully).
If you want to go to maintenance dialog go to setup.exe path in disk1 folder and run the setup.exe, you will see the maintenance dialog (Refer attachment)
Regards,
Vijay.A
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Thanks for the Reply.
I realized my mistake. I didn't set the Condition for InstallWelcome Dialog Under Custom Action and Sequence -> "Sequence".
Condition as "Not Installed"