Disable 'PRESS <ENTER> TO EXIT THE INSTALLER:' message in Console mode

[asavchenko]

Can we somehow disable message "PRESS <ENTER> TO EXIT THE INSTALLER:" in Console installer mode to let it finish atomatically?

[VineethaNair]

In  Console mode installation, panels in post-install phase are designed to accept
user action , whether to continue or exit.

As a workaround  :
If it is a simple installer with only Install complete panels in
the post-install phase,

To disable the status message & the "PRESS <ENTER> TO EXIT THE INSTALLER:"
message in Console installer mode & let it finish automatically,
Remove the Install Complete Panel found in Post-install sequence.

InstallAnywhere Designer->Sequence->Post-Install->Action Group: Console actions->
Select panel "Console : Install Complete : Installation Complete" -> Remove

[asavchenko]

Understood.

In this box there was also some message shown to user.
If I replace 'Install Complete' action with 'Important note' or 'Display message', would it also need user press something on keyboard or just show message and go to next step?

[VineethaNair]

Yes, it will also require user action.

In Console mode, all panels in pre/post-install sequence require user action to proceed.
Important Note & Display message panels will also require user action.
This is as per design in console mode installation.