- Revenera Community
- :
- InstallAnywhere
- :
- InstallAnywhere Forum
- :
- Re: Disable 'PRESS <ENTER> TO EXIT THE INSTALLER:' message in Console mode
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Disable 'PRESS <ENTER> TO EXIT THE INSTALLER:' message in Console mode
Can we somehow disable message "PRESS <ENTER> TO EXIT THE INSTALLER:" in Console installer mode to let it finish atomatically?
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
In Console mode installation, panels in post-install phase are designed to accept
user action , whether to continue or exit.
As a workaround :
If it is a simple installer with only Install complete panels in
the post-install phase,
To disable the status message & the "PRESS <ENTER> TO EXIT THE INSTALLER:"
message in Console installer mode & let it finish automatically,
Remove the Install Complete Panel found in Post-install sequence.
InstallAnywhere Designer->Sequence->Post-Install->Action Group: Console actions->
Select panel "Console : Install Complete : Installation Complete" -> Remove
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Understood.
In this box there was also some message shown to user.
If I replace 'Install Complete' action with 'Important note' or 'Display message', would it also need user press something on keyboard or just show message and go to next step?
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Yes, it will also require user action.
In Console mode, all panels in pre/post-install sequence require user action to proceed.
Important Note & Display message panels will also require user action.
This is as per design in console mode installation.