- Revenera Community
- :
- FlexNet Publisher
- :
- FlexNet Publisher Forum
- :
- Lmstat blocked
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Lmstat blocked
We have several sites behind firewalls that pull Flexnet publisher licenses from our license server. We had to open the vendor and lmgrd ports in the firewalls to allow this to work. Unfortunately lmstat does not work from the firewalled sites. Is there a port or protocol we need to open so lmstat will pass back results to sites behind the firewalls?
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
@radamsL3Harris please try the following syntax...
lmstat -a -c 27001@<serverhost>
...replacing the port and server with yours.
Hope this helps.
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
I have the same problem. ..."sites behind firewalls that pull Flexnet publisher licenses from our license server. We had to open the vendor and lmgrd ports in the firewalls to allow this to work... " We can successfully check out licenses. But, "...Unfortunately lmstat does not work from the firewalled sites."
I already use "lmstat -a -c <port>@<host>"
Well, for at least one of the license servers behind the firewall, "lmstat" works fine. But for at least another one, lmstat responds with
lmgrd is not running: License server machine is down or not responding. (-96,7)
which is a fairly generic response. The license server machine is up, since I can get licenses from it. So, it must be "not responding".
Is there some way to debug this?
Thanks for any help!
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Hi @JerryH ,
The vendor and lmgrd port should always be open for communication .
I would also suggest you to add the the server name and IP address to the file C:\Windows\System32\drivers\etc\hosts and then give it a try.