This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- Re: Setup.exe doesn't elevate UAC
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Nov 26, 2012
09:53 AM
Setup.exe doesn't elevate UAC
My InstallScript MSI project under IS11.5 used to automatically request elevated privileges when setup.exe was first run. Having ported the project to 2012 it goes through a lot of preamble and then fails because the user isn't an administrator, even though the user is in the admin group.
How do you set the right privileges from the get go? (Without having to tell the user to right-click > Run As Administrator)
How do you set the right privileges from the get go? (Without having to tell the user to right-click > Run As Administrator)
(3) Replies
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Nov 26, 2012
10:59 AM
Have found the appropriate setting.
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Nov 27, 2012
06:03 AM
Would you please tell the settings...:)
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Nov 27, 2012
06:51 AM
Releases > Setup.exe [tab] > Required Execution level