This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- Repair” and ‘Upgrade’ do not work as expected.
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Oct 31, 2024
03:18 AM
Repair” and ‘Upgrade’ do not work as expected.
The application is not updated and remains in the same state as before.
The expected behavior is that the application is replaced by the launched EXE application.
I would like to know if there is any setting necessary for the above.
If possible, we would like you to send us a Setup.exe or InstallShield project and point out what is wrong.
If the debugger can also check the validation results, I can send you a link to the spreadsheet and the Setup.exe that was used for validation.
(0) Replies