This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- Re: Error 2753 The File xxx is not marked for installation
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Jan 21, 2009
05:01 PM
Error 2753 The File xxx is not marked for installation
I am getting this error on an upgrade. I found an explanation that makes sense on this link:
http://community.acresso.com/showthread.php?t=184418&highlight=marked
The suggestion was "The condition on the custom action should be changed to account for the fact that the component the file belongs to may not be installed". So how do you do this? I also dont mind setting a component to always install even if it wasnt updated. Is that possible and how?
Thanks,
Ray
http://community.acresso.com/showthread.php?t=184418&highlight=marked
The suggestion was "The condition on the custom action should be changed to account for the fact that the component the file belongs to may not be installed". So how do you do this? I also dont mind setting a component to always install even if it wasnt updated. Is that possible and how?
Thanks,
Ray
(1) Reply
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Jan 22, 2009
03:27 PM
You can right click on the file inside of the component and select "Properties" and then "Always over write"
The most likely better solution is to place a component action condition on the Action that you have designed. For more info on those see here:
http://www.appdeploy.com/articles/msicustomactions/
The condition should look something like:
$MyComponent=3
The most likely better solution is to place a component action condition on the Action that you have designed. For more info on those see here:
http://www.appdeploy.com/articles/msicustomactions/
The condition should look something like:
$MyComponent=3