- Mark as New
- Subscribe
- Mute
- Permalink
- Email to a Friend
- Report Inappropriate Content
Apr 02, 2013
10:42 PM
Component level condtion not working during Modify
Hi,
I am using multiple features. Based on feature selection, I am updating property and added that property condition in component condition table. So, it is like CHECKFATURE = "ABC".
When I do installation, it works fine. But when I modify that install product, i again reach to select features. But here components are not coming based on this condition.
Please suggest about this?
Thank you,
Regards,
Kaushal Kumar
I am using multiple features. Based on feature selection, I am updating property and added that property condition in component condition table. So, it is like CHECKFATURE = "ABC".
When I do installation, it works fine. But when I modify that install product, i again reach to select features. But here components are not coming based on this condition.
Please suggest about this?
Thank you,
Regards,
Kaushal Kumar
1 Reply
- Mark as New
- Subscribe
- Mute
- Permalink
- Email to a Friend
- Report Inappropriate Content
Apr 12, 2013
06:17 PM
You will need to set Reevaluate Condition in Component Settings.
