This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- Re: Setup Types during uninstall problem
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Aug 03, 2007
09:58 AM
Setup Types during uninstall problem
In our installation project. The Setup Types are immediately displayed during a first-time installation. This setup type dialog also is displayed first, after the user has already installed the application but launches the install.exe. So in effect, to uninstall the application, they have to first select the installation type, again.
Is there any way to skip the Setup Type dialog screen if the application has already been installed?
If so could you please guide me in the right direction.
Thanks.
Ken
PS: The project type is an InstallScript project.
Is there any way to skip the Setup Type dialog screen if the application has already been installed?
If so could you please guide me in the right direction.
Thanks.
Ken
PS: The project type is an InstallScript project.
(2) Replies
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Aug 03, 2007
10:17 AM
The code that displays the dialogs in maintenance mode can be found in OnFirstMainUIBefore. You can change the code in this event so that this dialog is not shown.
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Aug 03, 2007
04:41 PM
Sorry Eric, I'm a newbie to InstallShield.
I'm working with a large installshield installscript another developer designed.
I couldn't find the OnFirstMainUIBefore mentioned. I did see a Before Move Data -> OnMaintUIBefore. Perhaps this is the method? Our logic to call this Setup Type was located in the Before Move Data -> OnBegin Method.
I just had to put a
if !MAINTENANCE then
around the call.
Thanks for the help.
I'm working with a large installshield installscript another developer designed.
I couldn't find the OnFirstMainUIBefore mentioned. I did see a Before Move Data -> OnMaintUIBefore. Perhaps this is the method? Our logic to call this Setup Type was located in the Before Move Data -> OnBegin Method.
I just had to put a
if !MAINTENANCE then
around the call.
Thanks for the help.