- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- Repair” and ‘Upgrade’ do not work as expected.
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Repair” and ‘Upgrade’ do not work as expected.
The application is not updated and remains in the same state as before.
The expected behavior is that the application is replaced by the launched EXE application.
I would like to know if there is any setting necessary for the above.
If possible, we would like you to send us a Setup.exe or InstallShield project and point out what is wrong.
If the debugger can also check the validation results, I can send you a link to the spreadsheet and the Setup.exe that was used for validation.
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
We have a great video that is an introduction to Windows Installer Upgrades - please take a look at the link below. It will hopefully point you in the right direction to create an upgrade for your installer:
https://community.flexera.com/t5/InstallShield-Knowledge-Base/Introduction-to-Windows-Installer-Upgrade-Types/ta-p/193041