This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- Re: .NET 1.1 on Vista, "may not have installed correctly" message
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Jun 17, 2007
01:55 PM
.NET 1.1 on Vista, "may not have installed correctly" message
I use IS 2008 with a Basic MSI project... I have .NET 1.1 included in the project and everything works fine on XP...
With Vista if .NET 1.1 is not already installed, half way through installing it you see "may have not installed correctly". If you tell it that it has, then it works fine...
How can I remove this message? If I manually run 1033dotnetfx.exe and the SP1 they install just fine...
I read about this in IS 12, but assumed it would already be fixed in IS 2008.
The only reason I purchased IS 2008 was for Vista compatiblity, is this not possible? Do I have to use CA?
david
With Vista if .NET 1.1 is not already installed, half way through installing it you see "may have not installed correctly". If you tell it that it has, then it works fine...
How can I remove this message? If I manually run 1033dotnetfx.exe and the SP1 they install just fine...
I read about this in IS 12, but assumed it would already be fixed in IS 2008.
The only reason I purchased IS 2008 was for Vista compatiblity, is this not possible? Do I have to use CA?
david
(3) Replies
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Dec 18, 2007
12:07 PM
veetid wrote:
I use IS 2008 with a Basic MSI project... I have .NET 1.1 included in the project and everything works fine on XP...
With Vista if .NET 1.1 is not already installed, half way through installing it you see "may have not installed correctly". If you tell it that it has, then it works fine...
How can I remove this message? If I manually run 1033dotnetfx.exe and the SP1 they install just fine...
I read about this in IS 12, but assumed it would already be fixed in IS 2008.
The only reason I purchased IS 2008 was for Vista compatiblity, is this not possible? Do I have to use CA?
david
I just ran into this problem and was wondering if you got it resolved
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Dec 19, 2007
12:20 PM
Have you installed the hotfix described on our KB?
http://support.installshield.com/kb/view.asp?articleid=Q113498
http://support.installshield.com/kb/view.asp?articleid=Q113498
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Dec 19, 2007
12:25 PM
MichaelU wrote:
Have you installed the hotfix described on our KB?
http://support.installshield.com/kb/view.asp?articleid=Q113498
Sorry, should have replied to the my earlier post yesterday, after some searching I did find the hotfix mentioned above and it did take care of the issue that I was encountering.