This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- Re: File [WindowsFolder]Microsoft.NET\Framework\v2.0.50727 not found
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Jun 08, 2011
03:36 AM
File [WindowsFolder]Microsoft.NET\Framework\v2.0.50727 not found
Dear Flexera Friends,
today i reaches a mysteric failure while creating a single Disk Image using Installshield 2010 Express.
During the build process there occurs this error:
ISEXP : error -1024: File [WindowsFolder]Microsoft.NET\Framework\v2.0.50727 not found. Cannot stream the file into the Binary table
The mystery is, that i can't find any reference onto the .NET 2.0 Framework. From my point of view, this is not a part within the project. So my quesion is,
why and where does the InstallShield reference by itselfs onto this directory.
From where does it require the directory (of course .NET 2.0 Framework isn't installed onto this machine - there is the .NET 3.5 and .NET 4.0 be installed).
Is there anyone outhere who can give me a hint how to solve this?
THX in dolby
Oliver
today i reaches a mysteric failure while creating a single Disk Image using Installshield 2010 Express.
During the build process there occurs this error:
ISEXP : error -1024: File [WindowsFolder]Microsoft.NET\Framework\v2.0.50727 not found. Cannot stream the file into the Binary table
The mystery is, that i can't find any reference onto the .NET 2.0 Framework. From my point of view, this is not a part within the project. So my quesion is,
why and where does the InstallShield reference by itselfs onto this directory.
From where does it require the directory (of course .NET 2.0 Framework isn't installed onto this machine - there is the .NET 3.5 and .NET 4.0 be installed).
Is there anyone outhere who can give me a hint how to solve this?
THX in dolby
Oliver
(1) Reply
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Jun 08, 2011
06:26 AM
This is a common problem. When we add some file to Binary Table(manually or via Custom Action Wizard etc.) and later change the path, new entries are created. But the old references still remain. May be you too are facing the same.
In any case:
Check your Binary Table thoroughly. There might be some entry that stilll references that path. You need to manually remove it.
In any case:
Check your Binary Table thoroughly. There might be some entry that stilll references that path. You need to manually remove it.