This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- InstallShield
- :
- InstallShield Forum
- :
- Re: Build creates unwanted MSI and INI files
Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Dec 06, 2010
12:55 PM
Build creates unwanted MSI and INI files
I normally just want the output to be an EXE file.
A setup project is creating these files even though they are not selected.
- MSI
- Setup.ini
- 0x0409.ini
Why is this happening?
Thanks
Tom
A setup project is creating these files even though they are not selected.
- MSI
- Setup.ini
- 0x0409.ini
Why is this happening?
Thanks
Tom
(3) Replies
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Dec 07, 2010
02:46 AM
Hi,
Could you try creating a compressed setup.
Kindly refer the following thread.
http://community.flexerasoftware.com/showthread.php?t=195838
Regards,
Lenwin
Could you try creating a compressed setup.
Kindly refer the following thread.
http://community.flexerasoftware.com/showthread.php?t=195838
Regards,
Lenwin
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Dec 08, 2010
01:34 PM
Lenwin,
Thanks for your reply.
The setup.exe is compressed. Most of the other ISLE projects just create the EXE. I have had two that created the four files listed below.
It must be some setting, but I cannot find which one it is.s
Also, if I try to just run the setup.exe, I get this error: Error reading setup initialization file
Thanks
Tom
Thanks for your reply.
The setup.exe is compressed. Most of the other ISLE projects just create the EXE. I have had two that created the four files listed below.
It must be some setting, but I cannot find which one it is.s
Also, if I try to just run the setup.exe, I get this error: Error reading setup initialization file
Thanks
Tom
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
‎Dec 08, 2010
07:12 PM
Found answer:
The type of output is set in VS 2010!
- Right-click on the VS 2010 Solution
- Select Configuration Manager
- For the "setup" project select "SingleImage"
- Click Close button
Now there will be a single EXE file in the ISLE output folder.
Thanks
Tom
The type of output is set in VS 2010!
- Right-click on the VS 2010 Solution
- Select Configuration Manager
- For the "setup" project select "SingleImage"
- Click Close button
Now there will be a single EXE file in the ISLE output folder.
Thanks
Tom