- Revenera Community
- :
- InstallAnywhere
- :
- InstallAnywhere Forum
- :
- Installanywhere custom variable not working in silent mode
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Installanywhere custom variable not working in silent mode
Hello Team,
We are using IA 2021 version. In our installer, we are using a custom variable which store input from user and write it into a text file. The mechanism is working fine in UI mode but not working in silent mode.
I tried to use 1) properties file and 2) passed the variable in command line with -D parameter.
Both are not working. Also there are no conditions restricting the action from writing the variable in silent mode.
Please suggest on this.
thanks
Sumit
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Hi,
Passing the variable value from command line using -D should work in silent mode.
Please try the below steps :
In InstallAnywhere Designer->Sequence->PreInstall->Add Action->General, add a "Modify text file- Single File" action
Configure the action :
Existing File : Add path of file to be modified
Additional Text : $my_variable$
Select Append or prepend option
[Please refer Variable.png file attached ]
Build the installer
Run the installer from command line in silent mode using the below command:
install.exe -i silent -Dmy_variable=testvalue
The file gets modified with the variable value passed as argument. If the file is getting modified when run in GUI mode, then same should work with silent mode, Unless some action is present which prevents modifying the file or resets the value of the custom variable. If the issue persists, please do attach the log file.
Hope this helps.
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Hello Vineetha,
Thanks for your reply. The steps mentioned in the solution suggested are already implemented in my installer. I have attached the settings in the screenshots. Please check
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Hi,
Tried replicating the issue with Modify text file action "configure" settings as well and the value passed with -D is getting properly replaced in silent mode. Issue could not be reproduced in the setup here. Seems like some configuration is different in your setup.
Could you please try creating a new project with the same steps mentioned in my previous comment? Use the installed file option if you want to modify a file the installer deploys on the target system. Could you please create a new project with only the "Modify text File" action with the same configuration in your setup and attach, so that we can help resolve the issue?