This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- Revenera Community
- :
- Code Insight
- :
- Code Insight Knowledge Base
- :
- How to control the stream time for SCM connections when using the Copy Project functionality
Subscribe
- Mark as New
- Mark as Read
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
How to control the stream time for SCM connections when using the Copy Project functionality
How to control the stream time for SCM connections when using the Copy Project functionality
Summary
This article discusses the addition of a new property to the 6.12.3 release to control the stream timeout for SCM connections when using the Copy Project functionality.Synopsis
This article discusses the addition of a new property to the 6.12.3 release to control the stream timeout for SCM connections when using the Copy Project functionality.Discussion
A new property has been added to the core.properties file for FlexNet Code Insight 6.12.3 to allow greater control of the length of time a stream will be allowed to gather information from SCM connections when performing a Project Copy. This property was added as customers with large amounts of information being retrieved from SCM connections could not retrieve all of the necessary information when attempting to perform a Project Copy within the FlexNet Code Insight UI. The default length of time a stream was allowed was 3 seconds in versions 6.12.2 and earlier, testing has shown that this was not sufficient when attempting to gather over 500 Clearcase Views and VOB's. The new property will allow customers to increase the stream time to a maximum of 5 seconds. This value should not be exceeded as this can cause system instability. Customers wishing to use the new feature should be aware that increasing the value from 3 to 5 seconds will result in an additional 2 second delay when performing the Project Copy.The new property will be disabled and not shown in the core.properties file by default however it can be enabled using the following instructions:
- Shut down tomcat
- Open the core.properties file, located at '<Install dir>/config/core/core.properties', in a text editor
- Add the following line to the end of the file:
copy.project.delay.seconds = 5
- Save and close the file
- Restart tomcat
PLEASE NOTE: These settings cannot be used on any version earlier than 6.12.3
No ratings