Loading
search-img

KingVoodoo asked a question.

April 10, 2006 at 9:43 AM
Setting the initial state of a feature
How do I set the initial state of a feature in AdminStudio 11.5?

 

I'm creating a transform where I want to change a feature that is set to not available to install on local drive? Or is there another way of getting the feature installed? The install is run in silent mode.

 

Thanks :confused:
  • 3 answers
  • 70 views

  • dthornley1.5524927812509192E12

    There are a couple of ways you could do this. You could set the feature's condition in the IDE. If you are looking to do this from the command line you could set the ADDLOCAL and REMOVE installer properties to the feature name.

  • KingVoodoo

    Thanks,

     

    I tried ADDLOCAL but it didn't work :(

     

    The only way I get this to work is by setting required=yes in the feature's properties. :(

  • dthornley1.5524927812509192E12

    That would work. You could also check the Instal Level of the feature and make sure that it is defaulting to something other than zero if you still wanted to give the user running the setup the option to turn the feature off.

Related  Product Forums


                     → Flexera One



                      → Snow Atlas



                      → FlexNet Manager



                      → Snow License Manager



                       → App Broker


       Need help finding an answer?


        Ask a Question →


+1.800.374.4353
CONTACT SALES SUPPORT HUB FLEXERA REVENERA
© 2026 Flexera. All rights reserved.
Privacy policy Terms and conditions Revenera Community Help
Loading
Setting the initial state of a feature