The Community is now in read-only mode to prepare for the launch of the new Flexera Community. During this time, you will be unable to register, log in, or access customer resources. Click here for more information.
Hi,
I have deployed imgtrack and ndi file is also getting generated and send for processing.
Post reconciliation how this would be visible in flexera UI
will this be under
discovery&inventory >All inventory
or
Container inventory > All containers
Also, what will be the display name any dummy data that can help me understand . Nothing is much clear in the documentation
Thanks,
Ro**bleep**a
Dec 12, 2023 04:18 AM
Not sure if this is the easiest way to get to the scanned images but if you filter on 'ImageID not empty' in the All Containers view you should see them:
Thanks,
Dec 18, 2023 04:57 AM
Hi John,
There are no enteries in the containers section for the img track deployement. We checked for the reconciliation also this import is successfully in the importer logs.
Can you guide us further on how to troubleshoot this.
Thanks,
Ro**bleep**a
Dec 18, 2023 08:50 AM
try search with container hostname (or id) or with image id in the search field available at top right corner of "All Container" view.
Dec 19, 2023 02:53 AM - edited Dec 19, 2023 02:53 AM
Thanks junaid . But still no data
There is one checkbox in inventory settings as below
Enable detection of Docker and running inventory agent inside docker containers.
is this check mandatory. Can you point to the documentation if this is valid?
Thanks,
Ro**bleep**a
Dec 19, 2023 03:30 AM
I may have misunderstood your scenario into Kubernetes clusters when you referred to imgtrack. I will delete my response above if it's irrelevant to your use case.
However, if it is a Kubernetes scenario, did you deploy one of the Flexera Kubernetes agents as per Two FlexNet Kubernetes Agents and do you see any inventory from these in the All Containers view?
Thanks,
Dec 19, 2023 03:41 AM
Hi John,
No, i have deployed imgrtack that would run a static scan on container images. I am not putting anything inside the running containers.
Thanks,
Ro**bleep**a
Dec 19, 2023 03:51 AM
i think the setting you are referring at inventory setting page is for enabling container scanning at the devices with the help of already installed flexera inventory agent.
in your case, you are using standalone imtrack. this document speaks about the difference of both.
i recommends you to open a case with support, attaching the ndi generated by the imgtrack along with tracker.log and upload.log etc. there must be something went wrong at inventory gathering or processing, or may be the way it searched in UI.
Dec 19, 2023 04:19 AM