Setup.exe Silent Command line installer is not working
I think the syntax might be a little out here.
don't leave a space for example use: /v"/qn
Also as you are using an inverted comma after /v make sure that you close them - after SDSetupSilent.log would be a good place.
So in summary, try:
.exe /s /v"/qn /l*v %windir%SDSetupSilent.log" ALLUSERS=2 SDEBUG=1
Thank you for the quick reply.
The command is working only if I give as below.
.exe /s /v"/qn /l*v %windir%SDSetupSilent.log"
If I am trying to set the properties as part of the command then the installation is not happening.
Is there something going wrong here.