cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Flexera beginner

64 Bit COM extraction

Hi all,

Apparently, InstallShield 2010 now supports 64-bit COM extraction.

However, this doesn't seem to work for me. My components are marked as 64-Bit and "COM Extract at Build" is set to "Yes". However, the COM dlls are not registered after installation.

Any ideas?


Thank you.

Christophe
Labels (1)
0 Kudos
6 Replies
Highlighted
Occasional contributor

Re: 64 Bit COM extraction

I'm sure I'll be running into the same issue!
0 Kudos
Highlighted
Frequent contributor

Re: 64 Bit COM extraction

Is your InstallShield 2010 installed on a 64-Bit platform ?

regards

Markus
0 Kudos
Highlighted
Occasional contributor

Re: 64 Bit COM extraction

My InstShld 2010 is!!
0 Kudos
Highlighted
Frequent contributor

Re: 64 Bit COM extraction

What means "My InstShld 2010 is!!" ?

You can only extract com-registry data from a 64-Bit dll, if your InstallShield 2010 is installed on a 64-Bit platform/operating system.

regards

Markus
0 Kudos
Highlighted
Occasional contributor

Re: 64 Bit COM extraction

You asked if IS 2010 is installed on 64-bit platform, and it is.
0 Kudos
Highlighted
Pilgrim

Re: 64 Bit COM extraction

Hi

Did anyone get to the bottom of this issue as I am having similar problems. Only some of the registry data is extracted either at build or from using the "Extract COM data for Key file" option.

Also, using the self-register option causes the setup to fail.
0 Kudos