- Revenera Community
- :
- InstallAnywhere
- :
- InstallAnywhere Forum
- :
- Installation Step being highlighted wrongly during the Installation Step
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Im building an Installer with InstallAnywhere 2020 SP2 and facing a strange issue.
During the actual Installation step of the Installer , so the one that usually comes after 'Pre-Install Summary', on the left side of the GUI in the Installation Step List, the first step gets highlighted instead of the actual 'Installing...' step. (See Attached Image)
I looked through the Software and haven't found anything that pertains to this.
Any help is appreciated!
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Please check following setting
Navigate to Installer UI | Custom UI Designer, select Installer Steps under Installer Area dropdown
Click on Install Step Label Settings under Install Progress Panel.
Make sure correct label is selected.
PFA : installstepsetting.jpg
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Please check following setting
Navigate to Installer UI | Custom UI Designer, select Installer Steps under Installer Area dropdown
Click on Install Step Label Settings under Install Progress Panel.
Make sure correct label is selected.
PFA : installstepsetting.jpg