- Revenera Community
- :
- FlexNet Operations
- :
- FlexNet Operations Forum
- :
- Can't map part number to license model
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
How can I map a part number to a license model? I can map it to a product, but there's no dropdown or button for license model. How do i do this?
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Hi @testingflexera1 ,
When creating a Part Number you should see a pull down containing the license models that have been linked with target Product as shown in the screenshot below:
Thanks,
Jim
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Hi @testingflexera1 ,
When creating a Part Number you should see a pull down containing the license models that have been linked with target Product as shown in the screenshot below:
Thanks,
Jim
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
What happens if you don't identify a license model? Because apparently that's possible. What license model will be chosen for the entitlement if the partnumber is used?
- Mark as New
- Subscribe
- Mute
- Permalink
- Report Inappropriate Content
Hi @testingflexera1 ,
A Product must have at least one license model linked to it in order for it to be deployed and used in Entitlements. If you create a Part Number for a Product without specifying a license model, I believe it will use the first linked license model in alphabetical order based on a quick test. The intent of the Part Number is to link a Product with a License Model so it is always recommended to specify the License Model when creating the Part Number.
Thx,
Jim