Beacon Server - Tasks in Task Scheduler in Queued Status

[FrediG]

I am using beacon software v19 that came with FNMS 2022R2. We recently had to upgrade the O/S on our beacon servers from Windows Server 2012R2 to Windows Server 2019. We wiped the existing device and then install Windows Server 2019. After the installation and configuration of IIS, etc I install the FNMS Beacon Software. Change the UID in registry and load the config file. Installation went well with no errors. I did notice the beacon server is not reporting and when I went to check I could see no files are uploading. After some investigation I discovered the beacon tasks in the Windows Task Scheduler is showing a Queued status. I can run the tasks manually and the files get uploaded but then the task status goes back to queued. Anyone else experienced such a issue.  

[SNeddermeyer]

Only for being sure that this is not the reason:
You're not running that stuff on a laptop which is not connected to the power supply and the tasks are configured to run only when power is connected?

If not, please open the task and set "If the task is already running, then the following rule applies" in the tab "settings" to "stop the existing instance" and check what happen after saving.